How to Remove an Ice Maker from a Samsung Refrigerator

Last Updated on June 6, 2022 by Kimberly Crawford

If you’re like most people, you probably think that the only way to remove an ice maker from a Samsung refrigerator is by calling a technician. However, this is not the case! In this blog post, we will walk you through the steps on how to do it yourself.

It’s actually very easy and only takes a few minutes. So don’t wait any longer and follow these simple instructions!

In this article

Reasons why Samsung ice maker is not making any ice

Now that you have opened up your Samsung ice maker door, check out the following reasons why it might not be making any ice:

-The water line has been disconnected or there is a leak in the line leading to refrigerators. Make sure all connections are secure and no leaks exist. If these problems persist then contact customer service for assistance before attempting to fix the issue yourself.

-The ice maker is not turned on. Make sure the switch in the back of the machine is in the “on” position.

-The ice maker was recently turned off due to a full bin or too much ice being produced. Wait a few hours and then try turning it back on. If it still doesn’t work, then there might be a problem with the ice maker itself and you will need to call customer service for assistance.

-The water supply is turned off. Make sure the valve supplying water to your refrigerator is open all the way.

Cannot remove ice bucket from Samsung refrigerator

If you are having trouble removing the ice bucket from your Samsung refrigerator, it might be because the bucket is frozen to the bin.

To fix this, remove all of the ice from the bucket and then place a damp towel on top of the ice maker for about 15 minutes.

After that, try removing the bucket again. If it’s still stuck then try using a hair dryer on low heat to loosen up any frozen parts before attempting removal again.

Step by step on how to remove ice maker from Samsung refrigerator

Locate the release lever on the front of the ice maker and push it down. If there is no lever, you can try to remove ice maker by using a screwdriver.
Pull the ice maker straight out from the refrigerator.
Disconnect the power cord from the back of the ice maker.
If you have a water line connected to the ice maker, disconnect it from the back as well.
Remove the two screws that secure the ice maker to its mounting bracket.
Liftoff the ice maker assembly and disconnect it from any other wires attached to it.

How do I replace the ice maker from the Samsung refrigerator?

Steps are the same as above, except for the following:

– Reconnect any wires attached to the ice maker assembly.

– Lift the ice maker onto its mounting bracket and secure it with two screws.

– Connect the waterline, if you have one.

– Plugin the power cord.

– Push the release lever on the front of the ice maker and slide it back into place.

Samsung fridge ice maker how it works

Now that you know how to remove an ice maker from a Samsung refrigerator, it’s time to learn about how it works. The ice maker is responsible for making the ice that goes into your glass or cup.

It does this by taking water from the home’s water supply and then cooling it down so that it turns into ice. The water line runs from your kitchen sink through the back of fridge and connects to a valve on top of ice maker. When you press down on this lever, it opens up a small hole which allows water flow into tray compartment where cubes are formed.

The ice is then stored inside an insulated container until needed again later on in day when people want some more cold drinks. As you can see, the Samsung ice maker is a pretty nifty little machine and it’s definitely worth having in your refrigerator!

How to remove ice maker from a Samsung refrigerator

There are many ways to remove ice maker from a Samsung refrigerator.

One method is by using pliers or other tools such as hammer and chisel, which may be dangerous for your hands because it needs force to break the ice cubes off the metal plate inside fridge door panel.

Second way is with water heated up until boiling point (100°C), pour it over the ice maker and wait until cubes fall off. This way also can be dangerous because of scalding water. A safe and easy method to remove ice maker from Samsung refrigerator is by using a screwdriver or any other sharp object to detach the metal plate around the ice maker. After that, you can pull out the ice maker by hand.

If your Samsung refrigerator ice maker is not producing any ice, you can try to fix it before removing the entire part from the fridge. First, make sure that the freezer is turned on and there is power supplying to the fridge. If everything seems to be okay but the ice maker still doesn’t produce ice, you can try to reset it by pressing and holding down the RESET button for about five seconds until a beep sound is heard.

If everything seems fine but still doesn’t work, check if there are any ice cubes stuck in the pathway of water tube that leads from the fridge door panel into freezer compartment. If yes then you can try to dislodge them by using a thin object such as a chopstick. If there is still no luck, then you may have to replace the entire ice maker unit.

Samsung refrigerator ice makers are not expensive and can be easily found online or in local stores. Make sure that you get the correct model for your fridge before purchasing one.

Samsung Refrigerator Ice Maker replacement Parts:

1. Icemaker Assembly DA97-15217D

Replace every six months for optimal performance.

2. Defrost Thermostat (Part #: DA47-00244J)

This part senses the temperature of the evaporator coil during defrost cycle to determine when to shut off the heater and terminate the defrost cycle.

3. Icemaker Control Assembly (Part #: DA92-00222B)

This part controls the electrical functions of the icemaker and its components, including the fill valve and ice ejection door.

4. Defrost Heater Assembly (Part #: DA47-00301A)

This heater is used to melt the ice on the evaporator coil during the defrost cycle.

5. Water Inlet Valve (Part #: DA97-05223A)

This valve controls water flow into the ice maker and refrigerator. It is a good idea to test this valve every six months. If it doesn’t close all the way, it could allow water to flow into the refrigerator.

6. Evaporator Fan Motor (Part #: DA31-00146E)

This motor is used for cooling and defrosting in refrigerators, freezers and wine coolers. When this part fails or begins to fail, you may notice a lack of air flow or a lack of cooling.

7. Evaporator Cover (Part #: DA97-05417A)

This part protects the evaporator from dust and other debris, ensuring that your fridge is getting cool air properly. It also helps to keep moisture in check during defrost cycles by preventing warm, humid air from entering the fridge. If this part is dirty or damaged, it needs to be replaced.

8. Thermostat (Part #: DA97-05206A)

This thermostat helps to regulate the temperature inside your fridge by monitoring the compressor and evaporator fan motors. You may need to replace it if you are experiencing problems with your fridge’s cooling system.

9. Ice Bin Assembly (Part #: DA97-15218D)

This part is what you’ll need if your ice maker ever fails and you need to replace it. It comes with the wiring harness, water inlet valve and cover, and mounting bracket. It also includes the instructions necessary for installation.

There you have it! The steps necessary to remove and replace your ice maker, as well as the replacement parts you might need if something goes wrong. Be sure to test your water valves every six months to ensure that your fridge is still running smoothly. If you have any other questions, don’t hesitate to give us a call or shoot us an email. We’re always happy to help!

How to reset Samsung refrigerator ice maker

If your Samsung refrigerator ice maker isn’t working, you may need to reset it. This is a very simple process and should only take a few minutes.

To reset your ice maker, you will need to locate the “test” switch on your unit. This is usually located at the back of the refrigerator near where the water filter would be installed. If it is not there, look at the front or side panel for a small hole with a tiny button inside.

Press this button once and the ice maker should go through its cycle. If this does not work, then you will need to unplug the refrigerator and wait five minutes before plugging it back in again.

The next step is to check if there any other problems with your Samsung refrigerator ice maker such as a frozen water line or clogged drain tube that may be preventing the unit from making ice. If you have determined that there is a problem with the ice maker itself, then you will need to replace it.

How do you remove the ice maker cover on a Samsung French door refrigerator?

The ice maker cover on a Samsung French door refrigerator can be removed by gently pushing down and pulling out on the cover. There are two tabs located at the top of the cover that need to be released in order to remove it. Be careful not to break them off, as they will need to be re-installed once the new ice maker has been installed into place.

Do you have to remove the ice maker for a Samsung French door refrigerator?

You do not need to remove the ice maker for a Samsung French door refrigerator. However, if you want to replace it with another model or brand of refrigerator, then yes you will need to take the ice maker out first before reinstalling it back into the unit.

How do you remove the ice maker housing on a Samsung refrigerator?

The ice maker housing is located at the top of your fridge, just behind where you would normally find an egg tray if there were one installed. The cover can be removed by pulling down and outwards until it pops off from the tabs located at the top. Again, be careful not to break these off as they will need to be re-installed once the new ice maker is in place.

Once the cover has been removed, you will see the ice maker itself. You can now disconnect the power cord and water line by unscrewing them from their respective connectors. The water line can be easily removed by pushing down on the white clip and pulling it out from the connector. The power cord will need to be pulled out from the back of the ice maker.

Now you can remove the old ice maker by gently lifting it up and out from its housing. Make sure that you do not damage any of the wiring or tubes that are attached to it. If you do, then the ice maker will need to be replaced.

Reinstallation is the reverse of removal and should take no more than five minutes. Once everything is reconnected, plug in the refrigerator and wait for it to start making ice again. Congratulations, you have successfully reset your Samsung refrigerator ice maker!

How do you remove the ice dispenser for a Samsung refrigerator?

You can remove the ice dispenser from your fridge by opening up its door and pulling out on it. The top of the dispenser should be easily removable with little effort required if necessary at all, however some models may require some force to release them which is okay.

Once the dispenser is removed, you will see a small hole on the front or side of the fridge that is used to release the ice maker cover. This hole can be used to manually push down and reset your ice maker if it ever stops working. You may also need to use this hole if there is any other problem with your fridge that needs addressing.

Where is the reset button on Samsung ice maker?

There is no reset button on Samsung ice maker. The only way to reset it is by going through the entire start-up process again, or by using the hole that is located on the front or side of your fridge that dispenses ice.

This hole can also be used to manually push down and reset your ice maker if it ever stops working. You may also need to use this hole if there is any other problem with your fridge that needs addressing.

How do I open my Samsung ice maker door?

First, you will need to locate the release lever. It is located on the right side of the ice maker door and looks like a small metal tab. Gently push down on the tab and then pull the door open.

Related:

Conclusion

The Samsung fridge ice maker is located in the freezer compartment. To access your refrigerator’s icemaker, you’ll need to remove a few parts of the appliance and disconnect some wires before removing it from its housing.

If you’re unfamiliar with how to do this or don’t feel confident doing so on your own, we recommend contacting an authorized service technician for help.